The above diagram shows the connectors on the rear of a sealed beam unit. For explanations of each connection, see below.
The above diagram shows the connector which plugs into the sealed beam unit. NOTE:- This is the view at the FRONT of the connector -- so 3 on the connector goes to 3 on the lamp.
For explanations of each connection, see below.
1 = Main or High Beam (Blue/White wire)
2 = Dipped or Low Beam (Blue/Red wire)
3 = Earth (Black wire)
You can get all the fittings for headlamps from Vehicle Wiring Products here.
Page last edited:- 03 October, 2006